LOGIC

Category: Services

Logic is an additional service that EVE system provides. This plugin module allows you to simplify the creation of boolean functions for system integrators. Thanks to informatic programmation, installers avoid extra useless devices. This means necessity of less devices, less programmation  and above all a greater versatility for a different building automation system programmation.

Step by step support

Differently from other EVE plugin modules, this plugin is thought to be used on EVE Manager.

EVE Manager

“Logic” component is already visible on “Components Library” tab. However you necessarily need to download EVE Logic on your PC in order to make use of this additional service/component. EVE Logic installation will allow you to successfully use this component on your new project.

 

1. EVE Logic download

Select Tools tab from EVE Manager menu –> Plugins

Download EVE Logic in order to enable Logic plugin.

You can also check the plugin modules installation page.

2. Component’s properties

Once you have dropped Logic component to “My Component” area, “Component’s properties” area will show you component’s details.

Logic setting ask you to select components from drop down menu. If menu is empty (none) it means you missed to add the component on “My components” area.

Drag and drop to “My Components” area the components you need as inputs and outputs (switch components).

3. Inputs parameters

Drag and drop to “My Components” area the components you need as inputs (switch components). Then choose these switches as inputs from inputs’ parameters drop down menu. You can set up to four different inputs.

EVENT EDGE:

Set which change of states the logic need to consider for any specific switch: from OFF to ON (rising edge), from ON to OFF (falling edge) or both of them. Infact, the logic will act as soon as inputs’ events occurr.

4. Operation setting

Set the operation of your Logic. Choose between AND, OR, XOR, NOT.

5. Outputs parameters

Drag and drop to “My Components” area the components you need as outputs (switch components). Then choose these switches as outputs from outputs’ parameters drop down menu. You can set up to four different outputs.