KNX GATEWAY TUNNEL FOR ETS


DESCRIPTION
The KNX Gateway connects a PC to an EIB / KNX system via the EIB socket on our X1 servers in order to configure, parameterize and commission the EIB / KNX installation and the bus monitor using the ETS.

This diagram represents a typical installation of our server that allows the installer to control and configure our server.

KNX Gateway configuration


In order to use your X1 server as a communication gateway with ETS, it is recommended to start the ETS software before following the next steps:

STEP 1

Start EVE Manager Pro and connect from the Project -> Connect menu to your X1 server.

STEP 2

Once the connection has been established, go to the Tools -> Start KNX Gateway menu. This will initiate communication between the X1 server and the ETS software.

STEP 3

Now let’s move on to the ETS software, by selecting the Bus screen you will notice that the communication was successful. Under “Current Interface” you will find your X1 server while on the right of the screen all the network details of your server.

STEP 4

When the connection is established it will be possible to use all the ETS features. In this example, correct operation can be verified by selecting Bus Monitor, which once you press Start, will give you all the information of your devices in real time.

STEP 5

Once the configuration is over on ETS, go back to EVE Manager Pro and from the Tools menu click on Stop KNX Gateway.